Emittion Electro is an automatic transfer switch manufacturers. Our automatic power transfer switches have reliable mechanical interlock, high arc-quenching performance and high transfer speed. W Series Dual-power Automatic Transfer Switches The W Series belong to the PC level, and include the types of W2 and WN3. W-2 is a two-stage automatic transfer switch. After a switching signal is received the switch transfers power immediately from one source to the other without stopping at an OFF position in the middle. The rated current is 20A~500A. The WN3 is a three-stage automatic transfer switch. After a switching signal is received the switch transfers power immediately, or after a preset delay, or stop at an OFF position in the middle. The rated current is 20A~5000A.
Characteristics of ATS switches Reliable mechanical interlock: Special eccentric selection construction to ensure only one power source is connected. High arc-quenching performance: Extinguishes abnormal electrical arcing, short duration of electric arcing and low contact loss. Multi-disc main arc contract: Enhances the contact area and pressure of contact surfaces, eliminating overheating and contact welding and extending contact lifespan. High Transfer speed: Rapid transfer between the active power and standby power, allowing a customized transfer delay for an ATS with a controller. Simple construction and small volume: Have reliable operation, a low failure rate and are convenient to install and maintain. Allow rotation with a handle during repair for convenient error detection and troubleshooting. The ATS of the W series are at PC level, are smaller than those of CB level, but have a higher current rating.